Operation; Lighting Instructions; To Turn Off Gas To Appliance - Montigo L42DF Installation & Maintenance Manual

L42DF* Indoor Gas Fireplace
Section 9: Start-up Sequence
For Your Safety - READ BEFORE LIGHTING:
A. This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIgHTINg smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
What To Do If You Smell gas:
■ Do not try to light any appliance.
■ Do not touch any electrical switch; do not use any phone in your
building.
■ Immediately call your gas supplier from a neighbour's phone.
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3.
Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas, including
near the floor. If you then smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't smell gas, go to the
next step.
5. Locate pilot burner (See illustration at right.) and follow steps below.
6.
Turn knob on gas control counter clockwise
NOTE: Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
1.
Turn off remote switch.
2.
Lift out the lower Horizontal access panel.
Page 22

Operation

with American Flame Electronic Ignition
WARNING
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.

Lighting Instructions:

to "OFF."
to "PILOT."

To Turn Off Gas To Appliance:

Follow the gas supplier's instructions.
■ If you cannot reach your gas supplier, call the Fire Department.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand, don't try
to repair it, call a qualified service technician. Force or attempt to repair
may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system, and any gas control which
has been under water.
7.
Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about (1)
minute after the pilot is lit. Release the knob and it will pop back
up. Pilot should remain lit. If it goes out repeat steps 3 through 8.
I ■ f knob does not pop up when released. Stop and immediately
call your service technician or gas supplier.
■ If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
8. Push in gas control knob and turn counter-clockwise
"ON."
9.
Replace the lower Horizontal access panel.
10. Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
Do not force.
4. Replace the lower Horizontal access panel.
with Continuous Pilot
Models
L42DFN
L42DFL
clockwise to "Off".
XG0181 - 112811
to