Operation; Start-Up Sequence With Continuous Pilot - Montigo H38DF ST Installation & Maintenance Manual

Section 9: Start-up Sequence
For Your Safety - READ BEFORE LIGHTING:
You must read and understand this manual prior to installation, operation or
troubleshooting this appliance. Please retain this owner's manual for furure reference
and maintenance.
A. This appliance has a pilot which must be lit by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
„
Do not touch any electrical switch; do not use any phone in
„
your building.
Immediately call your gas supplier from a neighbour's phone.
„
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Push in gas control knob and turn clockwise
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, STOP! Follow
"B" in the safety information above on this label. If you don't
smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow steps
below.
NOTE: Gas control knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
XG0207 - 011012.1

Operation

Standing (Continuous) Pilot Ignition
with American Flame Electronic Ignition
NOTICE
Lighting Instructions:
to "OFF."
To Turn Off Gas To Appliance:
(SIT NOVA 820)
Models Included
H38FSDN
Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire Department.
„
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
6. Turn knob on gas control counter clockwise
7. Push in gas control knob completely and hold. Light with Piezo
Igniter button. Continue to hold the control knob in for about
(1) minute after the pilot is lit. Release the knob and it will pop
back up. Pilot should remain lit. If it goes out repeat steps 3
through 8.
If knob does not pop up when released. Stop and immediately
„
call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control
„
knob to "OFF" and call your service technician or gas supplier.
8. Push in gas control knob and turn counter-clockwise
"ON."
9. Replace the lower Horizontal access
panel.
10. Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
"Off". Do not force.
4. Replace the lower Horizontal access panel.
H*38DF ST Indoor Gas Fireplace
H38FSDL
to "PILOT."
clockwise to
Page 23
to