Programmed Play - Sharp XL-HP600E Operation Manual

! Programmed play

You can choose up to 32 selections for playback in the order you
like.
1
Whilst in the stop mode, press
the MEMORY/SET (MEMORY)
button to enter the programming
save mode.
2
Press one of the DISC SELECT
- ( 1 - 3) buttons to select
the desired disc.
3
Press the direct search buttons
on the remote control to select
the desired track.
You can also select a track by pressing the
4
Press the MEMORY/SET (MEMO-
RY) button to save the track
number.
5
Repeat steps 2 - 4 for other tracks. Up to 32 tracks can be
programmed.
If you make a mistake, the programmed tracks can be cleared
by pressing the CLEAR button.
6
Press the (CD ) button.
The total number of memory will ap-
pear.
7
Press the / button to start playback.
During programme play, the DISC SELECT
buttons will not work.
To clear the programmed selections:
Press the CLEAR button on the remote con-
trol whilst the "MEMORY" indicator is flashing.
Each time the button is pressed, one track will be
cleared, beginning with the last track programmed.
To cancel the programmed play mode:
Whilst in the stop mode and the "MEMORY" indicator is lit, press the
CLEAR button on the remote control. The "MEMORY" indicator will
disappear and all the programmed contents will be cleared.
Adding tracks to the programme:
If a programme has been previously stored, the "MEMORY" indica-
tor will be displayed. Then follow steps 1 - 6 to add tracks. The new
tracks will be stored after the last track of the original programme.
Selected disc number
To check which tracks are programmed:
Whilst the unit is stopped in the programmed play mode, press the
or
Notes:
" Opening the disc tray automatically cancels the programmed sequence.
" Even if you press the ON/STAND-BY button to enter the stand-by
mode or change the function from CD to another, the pro-
grammed selections will not be cleared.
Selected track number
" During programme operation, random play is not possible.
or button.
! Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
" Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
" Keep your discs away from direct sunlight, heat, and excessive moisture.
" Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
- ( 1 - 3)
03/1/31
button.
NO YES
Correct
XL-HP600E(E)2.fm
XL-HP600E
17