Fueling - X-TREME XG-470 Owner's Manual

Fig. 5
Fig. 6
Fig. 6a
Fig. 7
Fig. 7a

Fueling

This is a two-stroke engine.
5. Install the enclosed Rear Fender bolts to secure
the fender to the frame. There will be one for
the rear of the fender, and two for the front.
6. Next, install the fuel tank and fuel lines. (Fig. 5)
First run the fuel lines from the right side of the
scooter under the fender to the left side of the
scooter to the engine and locate the carburetor.
Connect the clear line (return fuel line) to the
carburetor attaching it to L-shaped smooth
nipple. Attach the black line (feed fuel line) to
the carburetor attaching it to the ribbed nipple.
(Fig. 6)
7. Next mount the fuel tank to the scooter frame
using the two enclosed bolts.
Disregard the top-mounting bracket on the fuel
tank, as it is not necessary for this model of
scooter.
8. Seat and Seat post mounting. Locate the upper
and lower seat posts as shown. (Fig. 7) Attach
the upper seat post (short post) to the seat and
tighten the seat-mounting bracket. (Fig. 7a)
9. Using one of the two enclosed seat post
clamps, slide the clamp over the seat post
receiver, then insert the lower seat post.
Tighten clamp as necessary.
10. Slide the second seat post clamp over the lower
seat post and insert the upper seat post with
seat attached. Adjust the seat to the desired
height, and tighten the clamp. (Fig. 8)
11. Attach the trunk rack to the seat post at the
desired height. Tighten the nuts/bolts. Next,
attach the trunk to the rack using the enclosed
rubber washers and nuts/bolts.
Fig. 8
Fig.10
Page9
(Fig. 6a)