Transporting And Storage - X-TREME XG-470 Owner's Manual

Only run the engine using a mixture of gasoline and 2-cycle engine oil.
PLEASE READ OPERATING PROCEDURES BEFORE FUELING!
1. Mix fuel (minimum 90 octane) and 2-cycle engine oil in separate container.
Use Tanaka Perfect Mix or a quality 32:1 2-cycle oil. Make sure the fuel is
well mixed by shaking the container
2. Make sure that the engine is off!
3. Slowly open the GAS CAP, so that possible over-pressure disappears.
4. Clean the tank cap area to make sure that it is free from excess dirt and
debris.
5. *Make sure that no dirt falls into the gas tank.
6. Pour pre-mixed Gas/Oil mixture into the GAS TANK. *Do not overfill.
7. After fueling, replace the GAS CAP and tighten.
Riding
1. Make sure that all of the exposed bolts and screws are tightened.
2. Raise the kickstand to its upright position.
3. Make sure the engine is running.
4. Put one foot on the deck of the XG-470 while pushing off with the other
foot, gently rotate the THROTTLE GRIP, on the right side of the
handlebars. The XG-470 will begin to move on its own power.
5. Control your speed by rotating the accelerator grip. The more you rotate,
the faster you will go.
Braking
1. To brake, release the THROTTLE GRIP and depress the BRAKE LEVERS
(on the left/right side of the handlebars)
2. Gradually decrease the engine speed to idle and press the kill switch
button located just to the left of the throttle grip. This will turn the engine
OFF.
TRANSPORTING/STORAGE
Your XG-470 is easily disassembled for compact storage or transporting by
folding the handlebar and removing the seat post from the scooter.
Page10