X-TREME XB-502 Owner's Manual page 14

Battery Charging Safety Notes
1) While charging the Battery, keep the key switch OFF.
2) Verify that you are using the correct charger for your vehicle, and that the charger input
power is compatible the "house current" in your area.
3) Keep the charger and battery away from water to prevent electrical shock and shorting.
The charger is intended for indoor use only.
4) Plug the end of the charger's cord into the socket of the adaptor first. Next connect the
adaptor to the XB-502 (the charger port in located below the front of the seat). Then plug
the chargers' AC cords into the wall outlet.
5) Read the charger label to learn about the charger indicator lights, and their meanings.
6) Generally, a short drive will require a short time to re-charge, and a long ride will require
a longer time. A complete (90%) discharge may require 6 hours to recharge. To
prevent electrolysis (battery fluid loss by hydrogen generation,) do not charge for longer
than eight hours.
Do not place the battery near heat or fire. Do not expose the chargers to water.
1. Your bike comes with a 30amp fuse, pre-installed at the factory and is located inside the
battery box.
2. Clean Chain Regularly.
3. Ensure Tires are inflated to 35-45 PSI.
4. Adjust Brake tension via adjusting screws located at Brake lever or on Brake control
lever.
5. Ensure regular servicing according to the schedule.
6. Do not attempt to change any electronic components except changing light bulbs.
7. DO not attempt to modify, open or perform maintenance on the Hub Motor.
8. Any attempt to modify or adjustment of electrical components will void the warranty.
WARNING
Maintenance ----Basic
14