SATO GY412 Operator's Manual page 192

Section 8: Appendix
8.3 HEAD CHECK MOTION (cont'd)
Head check will be performed after printing the second label in the first item *1, after printing the first label in
the second item and after printing the third label in the second item. Then, the printer will feed the label
backward before starting the next print job. In this case, head check will be performed three times.
*1 Print method: One side indicates the print data for upper surface. Double side indicates the print data is
ready for both upper and lower surfaces as a set.
Notes:
• When selecting "CHECK PAGE" and specifying the number of labels for two or less, head check pattern
will be the same as that of "ALL CHECK".
• The head check will not be performed if the number of labels in the last item is smaller than the specified
number of labels.
Page 8-10
GY412 Operator Manual