Troubleshooting By Led Indicators Diagnosis - Argox CP-2140 User Manual

Troubleshooting by LED Indicators Diagnosis

Normally, when the printer is in not working properly, the "Power"
LED blinks continuously, and printing and communication
between the host and printer stops. Refer to LED indications
listed below to understand possible solutions to resolve the
problems printer run into.
LED Indicators: Power and Ready LEDs blink at the same tempo
Power LED Ready LED
ON ON
OFF OFF
Possible Problems Solutions
Media sensor cannot Check the label path
index label gaps
Check the label sensor
Media out Install a new label roll
Paper jam Recover the jam
Compact Printer Series - User's Manual
Remarks
If a continuous label roll
is in use, set
"continuous media"
printing in driver
settings or commands.
39
LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems Solutions
Ribbon out Install a new
ribbon roll
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems Solutions
Serial IO error Check serial baud rate at
both of your system and
the printer.
Cutter has failed, or Check the cutter or
there is paper jam recover paper jam.
inside the cutter.
Other possible Contact the reseller for
Compact Printer Series - User's Manual
Remarks
Set "Direct Thermal"
printing by driver or
commands if no ribbon is
required.
Remarks
For serial
interface only
Only applicable
when cutter
mode to cutter
mode.
40