Argox CP-2140 User Manual page 38

3
Pull
4
5
2
75
Compact Printer Series - User's Manual
1
7. Remove Mylar Film from Printer Chassis. Thread Cutter
Cable through the hole where Mylar Film locates, and then connect to
JP9 connector (CUTTER) on printer main board. Cutter Cable should
go though the hooks under Printer Chassis to manage cables better.
Make sure Cutter Cable go upon the font side of Middle Cover.
8. Assemble back Printer Chassis and Middle Cover.
9. Pull the font side of Middle Cover. Then assemble back with
Bottom downward.
10. Fix the two screws to Bottom.
11. Install Cutter Module by fixing Cutter Bracket (item 6) on Printer
Chassis with screws.
Compact Printer Series - User's Manual
Printer
Chassis
Guiding Hole (Mylar Film)
Cutter Cable
76