Zoom RhythmTrak 234 Operation Manual page 34

• Enter a note longer than the minimum unit: Hold the pad down
and repeatedly press the [REPEAT/STEP] key. With each push of
the [REPEAT/STEP] key, the immediately preceding note is
extended by one unit.
[PAD]
When you press a pad, its LED lights up, indicating that the note
has been input. The [VALUE] display shows the current position in
the pattern (measure/beat).
A note longer than the entire pattern cannot be input. When the
input exceeds the pattern length, the note will only be as long as the
NOTE
pattern.
To erase a note, use the [REPEAT/STEP] key to move to the desired position. Then
7
STEP
press the corresponding pad while holding down the [DELETE/ERASE] key.
As you move the position with the [REPEAT/STEP] key, the LED of
a pad that has been input for the current position lights up.
Pressing the pad while holding the [DELETE/ERASE] key down
causes the LED to go out and the note will be erased.
To decrease the length of a note, use the [REPEAT/STEP] key to move to the
8
STEP
position where the note should stop.
Then press the corresponding pad while holding down the
[DELETE/ERASE] key.
During step recording, erasing the entire track is not possible.
NOTE
9
When recording is completed, press the [STOP] key.
STEP
The [REC] key LED goes out, and step recording ends.
Hold down
[STEP] [STEP]
Note duration
[STEP]
[B2]
Bass track
Bass track
[DELETE/ERASE]
[B2]
[DELETE/ERASE]
31