Page 1
1.6 –US- Final Sound Solutions B.V. Eisenhowerweg 8D 5466AC Veghel The Netherlands http://www.finalsound.com Final Sound, L.L.C. 500 West Cummings Park, Suite 2500 Woburn, MA 01801 T:(781) 938-6416 F:(781) 938-6415 FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Page 2
FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Page 3
FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
1. Welcome Thank you for buying the Final Sound S110 subwoofer. The S110 is carefully hand built using the finest materials available and is designed for maximum performance. This manual contains important safety information as well as helpful advice and should be carefully studied before use.
Because the S110 subwoofer is intended to form a combination with our 90i, 150i and 300i panels, it will usually output frequencies higher than 100Hz. For these applications we recommend a subwoofer position on the base line between the loudspeaker panels.
Page 7
The stereo loudspeaker’s position. • The full home theatre loudspeaker placement. • A preferred unequal distance between the side walls and the panels (a, b, c and d). • Figure 0 FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Low level outputs Switch able power supply (110/220V user selectable) The cabinet of the S110 uses 19mm thick high-density composite walls. The cabinet is finished in a beautiful black satin finish. The amplifier is a 100W RMS class A/B design. It features a large power transformer, oversized power supply capacitors, and a large external aluminum heat sink to ensure long- term cool operation.
Phase adjustment is critical to get proper subwoofer/speaker integration. The Low Pass control has a roll-off range from 40 Hz to 200 Hz. For use with Final Sound electrostatic panels the crossover is typically set to the lowest frequency an applied panel can produce.
When using the subwoofer’s high pass filtering, it’s possible to feed the full range stereo signal into the high level input and route the LINE OUT panel’s signal to the panel’s power amplifier. FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Page 11
Important The Final Sound S110 subwoofer, is specially designed to match the requirements of the Final electrostatic loudspeakers. The crossover frequencies to several models Final electrostatic panels are programmed inside the subwoofer just as the time and phase behavior.
Page 12
Choose the panel’s lowest frequency to start. You cannot use the subwoofer’s special high pass filter facilities for driving the • electrostatic panels. Follow Procedure A for adjusting the subwoofer. • FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Page 13
Connect the left and right front panels to the two channel power amplifier’s • loudspeaker binding posts. Connect the rear loudspeakers and the center panel to the other power amplifier’s • appropriate loudspeaker output terminals. FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Use, as an example, piano music to make the right adjustment. Readjust the volume control again. • If you have a dedicated stereo/surround setup guide/disc, refer to the directions • included in it. FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
PROCEDURE B – QUICK INSTALLATION- Using the Final Sound S110 special high pass filter facilities. In this position, the sub’s special high pass filter facilities are active. Basically, the incoming full range signal is split into a low pass filtered signal driving the subwoofer, and a high pass filtered signal driving the left and right front panels.
TABLE 2 Recommended Settings for High Pass Switch & Crossover (low pass control) Model: Size: SMALL SMALL SMALL SMALL Crossover setting: 150Hz High pass switch FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- 150i 300i 400i 130Hz 95Hz 65Hz...
Operational Guidelines As with all Final products, the S110 is designed to provide the highest level of performance. However, the S110 still has limits that should be observed. If the S110 begins to overload or heavily distort, turn down the bass or volume.
High Level Input Impedance 1 kΩ Effective Internal Volume 22 liters sealed with 400 grams of polyester stuffing Driver 8 inch long throw driver Approval ETL UL Can CE CB FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
We thank you and wish you great enjoyment with your new Final Sound product. Name: _________________________________________________________________________...
Depending on your electronics, in case of a separate pre amplifier, it’s sometimes possible to connect the subwoofer direct to the pre amplifier’s FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Yes, but first disconnect the AC-line. Clean only with a damp cloth. Never use cleansers or chemicals. Never leave a wet cloth on the surface of the cabinet. C 2006 Final Sound The Netherlands FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Page 26
FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R...
Need help?
Do you have a question about the S110 and is the answer not in the manual?
Questions and answers