(Figure 5) If you have an AV-receiver for five, six or seven channel Dolby Digital/DTS
surround sound which has separate pre out connections.
You can only use the subwoofer's special high pass filter facilities for driving the left
•
and right electrostatic front panels, if you connect an additional two channel power
amplifier.
Connect the AV-receiver's left and right RCA pre amp out terminals to the
•
subwoofer's left and right line in RCA terminals.
Connect the subwoofer's line out RCA terminals to the additional two channel power
•
amplifier's RCA input terminals.
Connect the left and right front panels to the additional two channel power amplifier's
•
loudspeaker binding posts.
Connect the rear loudspeakers and the center panel to the AV-receiver's appropriate
•
loudspeaker output terminals.
Adjust the 'speaker size' in the receiver's menu to LARGE. This will cancel the
•
receiver's LFE output and route all the low frequencies to the front channels.
Follow Procedure B for adjusting the subwoofer.
•
(+) If you use a standard AV-receiver (with integral power amplifiers) with separate
outboard power amplifiers.
You can use the subwoofer's special high pass filter facilities for driving the left and
•
right electrostatic front panels, if you use at least outboard power amps for the front
channels.
Connect the AV-receiver's left and right RCA pre amp out terminals to the
•
subwoofer's left and right line in RCA terminals.
Connect the subwoofer's line out RCA terminals to the additional two channel power
•
amplifier's RCA input terminals.
Connect the left and right front panels to the additional two channel power amplifier's
•
loudspeaker binding posts.
Connect the rear loudspeakers and the center panel to the outboard amplifier's
•
appropriate loudspeaker output terminals.
Adjust the 'speaker size' in the receiver's menu to LARGE. This will cancel the
•
receiver's LFE output and route all the low frequencies to the front channels.
Follow Procedure B for adjusting the subwoofer.
•
+ The connection scheme is according to Figure 6. Instead of applying one five channel amp, you use
combinations of mono, two channel and/or three channel chassis.
(Figure 6) If you use a separate Dolby Digital/DTS processor and outboard power
amplifiers.
You can only use the subwoofer's special high pass filter facilities by putting the
•
subwoofer into the circuit, driving the left and right electrostatic front panels.
Connect the processor's left and right RCA pre amp out terminals to the subwoofer's
•
left and right line in RCA terminals.
Connect the subwoofer's line out RCA terminals to the two channel power amplifier's
•
RCA input terminals for driving the front channels.
Connect the left and right front panels to the two channel power amplifier's
•
loudspeaker binding posts.
Connect the rear loudspeakers and the center panel to the other power amplifier's
•
appropriate loudspeaker output terminals.
FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US-
c FSS 2006R
13