Operations Commands - Runco LS-3 Series Installation & Operation Manual

Serial Communications

Operations Commands

Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
Remote Button
Keyname
asp.16.9
asp.4.3
asp.lett
asp.narr
pip.sw
pip.1
pip.2
pip.3
pip.4
pip.5
pip.off
pip.swap
pow.tog
lit.tog
➤
Operations commands allow more flexible and direct control of the projector. The syntax
for operations commands is as follows:
op <operation> <command>[CR]
(Precede <operation> and <command> with a space.)
The command type can be one of 5 functions:
Function
Set
Get
Increment
IR Code
Set 1 Set 2
(none) 0x9E 0xDE
(none) 0x9F 0xDF
(none) 0xA0 0xE0
(none) 0xA1 0xE1
0xA3 0xE3
PIP
(none) 0xA4 0xE4
(none) 0xA5 0xE5
(none) 0xA6 0xE6
(none) 0xA7 0xE7
(none) 0xA8 0xE8
(none) 0xA9 0xE9
0xAA 0xEA
SWAP
(none) 0xAC 0xEC
0xAD 0xED
LIGHT
Operations Control Commands
Command
= <value>
Makes the unit take that value.
?
Asks what the current value is.
+
Adds 1 to the current value.
74
Description
Apply 16:9 aspect ratio to the active
source.
Apply 4:3 aspect ratio to the active source.
Apply Letterbox aspect ratio to the active
source.
Apply 4:3 Narrow aspect ratio to the active
source.
Switch to next "PIP Select" state.
Change "PIP Select" to source 1.
Change "PIP Select" to source 2.
Change "PIP Select" to source 3.
Change "PIP Select" to source 4.
Change "PIP Select" to source 5.
Change "PIP Select" to off.
Swap the PIP image with the active source
image.
Toggles between power on and power off.
Activates remote backlighting only when
pressed momentarily. When held for five
seconds or more, the IR code for toggling
the projector I/O panel light is transmitted.
Action on unit
Runco LS-3/LS-5 Installation/Operation Manual