Runco QuantumColor Q-1500d series Installation & Operation Manual page 103

Table 4-4. Test Patterns and Their Suggested Usage
Pattern
Primary Alignment
Secondary
Alignment
Dual Alignment
Press MENU to exit test pattern mode.
Input Names: You can give each input a descriptive name. For example, you may want
to change the default input name to the type of source component connected to it:
"VCR," "DVD," "Laptop" et cetera. Input names can be up to 12 characters long.
To edit an input name, select Input Names from the Service menu. Press
an input and press ENTER. Use the
or to select a character to change. When you have finished editing the input name,
press ENTER or MENU.
To restore the default input name, press
"Restore" column. Then, press ENTER.
Display Device - Configure: The options in the Display Device - Configure menu allow
you to change the picture orientation, perform lens adjustments or access other,
display-device specific functions.
• Installation – Orientation: Select Picture Orientation from the Display Device -
Configure menu, then select Orientation to change the picture orientation to suit the
method of installation (Floor Front, Floor Rear, Ceiling Front or Ceiling Rear). Or, for
front-projection installations, use the Auto setting to have the projector automatically
determine the orientation (floor or ceiling) using an internal sensor.
• Display Info.: Select Display Info. from the Display Device - Configure menu to see the
projector serial number.
• Diagnostics: Select Diagnostics from the Display Device - Configure menu, then
select Red, Green, Blue, Yellow, Cyan or Magenta to display only that color channel
(simulating a filter of that color). This can be useful for calibration or measurement
purposes.
To restore the normal picture (all colors), select White.
• Altitude: Select Altitude from the Display Device - Configure menu to control the
operation of the projector's cooling fan.
In most cases, the default setting (Auto) will maintain the correct operating
temperature. If the display frequently turns off due to overheating, or in certain
high-altitude operating environments, you may need to change this setting to High.
Q-1500d Series Installation/Operation Manual
Suggested Usage
Use this pattern when aligning the
output from the projector's
primary or secondary optical
engines (refer to Power-Up
Sequence and Optical
Alignment Procedure on
page 51). Select Dual Alignment
to have both optical engines
output this pattern.
or buttons to change a character; press
repeatedly to highlight that input name in the
87
C o mp o s i t e
or to select
C o mp o s i t e
C o mp o s i t e
C o mp o n e n t
H D 1
H D 2
S C A R T
H D M I
H D M I
H D M I
H D M I
Operation
Input Names
Restore
1
Composite 1
2 Composite 2
3
Composite 3
Component
HD 1
HD 2
SCART
1
HDMI 1
2 HDMI 2
3
HDMI 3
4
HDMI 4