Runco Signature Cinema SC-30d Installation & Operation Manual page 45

6. Hold the lens assembly with the motor
facing right (toward the Runco logo).
Carefully insert the back of the lens
assembly into the hole in the lens flange.
Make sure to route the wire harness
Caution
away from the moving lens stages and
Motor Assembly, to prevent
unexpected disconnection or lens
damage.
7. Secure the lens to the projector using
the six (6), 9/64" Hex Mounting Screws
(two each at 12 o'clock, 9 o'clock and
6 o'clock).
8. Connect the lens motor to the
projector.
9. Re-install the front bezel that you
removed in Steps 2 and 3. Tighten the
Phillips screws on the bottom and top
of the bezel to secure it.
Runco SC-30d/SC-35d Installation/Operation Manual 29
Installation