Making A Phone Call - Jeep Compass User Manual

ELECTRONICS
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth
pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and BEEP.
• (After the BEEP), say "Uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP), say "pair a phone".
• Follow the audible prompts.
• You will be asked to enter a four-digit Personal Identification Number (PIN), which
you will later need to enter into your mobile phone. You can enter any four-digit PIN.
You will not need to remember this PIN after the initial pairing process.
• You will then be prompted to give the phone pairing a name (each phone paired
should have a unique name).
• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven
phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the
vehicle.

Making A Phone Call

• Press the Phone button
• (After the BEEP), say "dial" (or "call" a name).
• (After the BEEP), say number (or name).
Phonebook Edit
• Press the Phone button
• (After the BEEP), say "phonebook".
• (After the BEEP), say "new entry" or "list names" or "delete".
• Follow the prompts.
Receiving A Call – Accept (And End)
• When an incoming call rings/is announced on Uconnect™, press the Phone
button .
• To end a call, press the Phone button
Mute (Or Unmute) Microphone During Call
• During a call, press the Voice Command button
• (After the BEEP), say "mute" (or "mute off").
Transfer Ongoing Call Between Handset And Vehicle
• During a call, press the Voice Command button
• (After the BEEP), say "transfer call".
34
®
instructions in your cell phone user guide to complete the phone
to begin.
.
.
.
.
.