Changing How The Insert Effects Are Used - Boss MICRO BR Owner's Manual

Section 3. Using effects
6.
Use VALUE [-] [+] to select the patch
number into which you want to write your
edited patch.
7.
Press [TR4] (YES).
The display will ask "Are you sure?"
8.
If you are sure you want to write to the
patch, press [TR4] (EXE). If you decide
not to erase the song, press [EXIT].
When writing is completed, you're returned
to the effect screen.
66
Changing how the insert
effects are used
By default, the insert effects are connected
(inserted) directly after the input source. This
means that you'll be able to hear and record the
sound processed by the effect.
However, in some cases, you may wish to change
this method of connection.
The MICRO BR lets you change the location
where the insert effects are connected, thus
allowing you to use the effect in a variety of
ways.
To change how the insert effects are connected,
proceed as follows.
1.
Press [EFFECTS] and then press
CURSOR [ ].
2.
Press [TR1] (LOC).
fig.Disp-FX-loc-norm.eps
3.
Use VALUE [-] [+] to specify the location
where the insert effects are to be
connected.
INPUT <NORMAL>
This lets you monitor and record the sound that
is processed through the insert effects. Normally,
you should use this setting.
fig.03-110
TRACK 1
(REC)