Automatic Buttonhol - Janome Sewing Machine Instruction Book

Automatic Buttonhole
Machine Setting
Remove the finger guard before
attaching the automatic buttonhole
foot (R) (refer to page 12).
The size of buttonhole is
automatically set by placing the
button in the automatic
buttonhole foot (R).
The button holder of the foot
takes a button size up to 2.5 cm
(1˝) in diameter.
Make a test buttonhole on a
sample duplicating the fabric,
interfacing and seams of the
actual garment.
Place the button on the fabric
sample and mark the top and
bottom to determine the position
of buttonhole.
Use the interfacing on the stretch
fabrics.
q w e
Turn the handwheel toward you to raise the needle to its highest
q
position.
Raise the presser foot lifter.
Set the pattern indicator at "BH" by turning the pattern selector
w
dial.
Attach the automatic buttonhole foot (R).
e
NOTE: There should be no gap between the slider and spring holder
of the foot as shown above.
(NOTE)
There should
be no gap
Spring
Slider
holder
29