Installing The Optional Sym-E14 - Rockford Fosgate SYMMETRY EPX2 Installation & Operation Manual

Installing the Optional SYM-E14

B
B
A
B
A. Disconnect RDAT & Power from the main unit.
B. Remove Cover from main unit by unscrewing the six hex head
screws with the 3/32" Allen wrench supplied with the EPX
C. Remove 2 Jumpers on connector P5 corresponding to LOL, LRL,
LOR & LRR.
D. Remove the Top Half of the 2 Standoffs carefully by hand from
the main unit. It is not necessary to remove the top screws when
separating the standoff into its two segments.
E
P3
E. Install E14 carefully into header connections P3, P4 and P5.
F. Replace 2 Top Standoffs, with screws intact, carefully by hand.
( Do Not Overtighten. )
G. Replace Cover on the main unit with the six hex head screws.
H. Reconnect RDAT & Power to main unit.
I. Adapt E14 Software by selecting DCard from the Setup menu and
select E14 or refer to page 36 of your EPX
J. Congratulations! You have successfully installed your optional
Equalizer Module.
ATTENTION: To maintain your EPX
Authorized Rockford Fosgate Dealer install your new accessory.
B
® ®
™
B
P5
E
E
P4
D
C
P3
warranty, we recommend your
2
- 38 -
P5
P4
F
E
E
Manual.
2
D
.
2
F
E