Table of Contents
Advertisement
M
OUNTING
The mounting location of your EPX
have a great effect on the performance of your system. To provide
proper ventilation the EPX
possible.
Trunk Mounting
Mounting the EPX
adequate room for the connection of cables and be careful not to
mount the unit near any vehicle computers or sources of high voltage.
Mounting the RDAT in the trunk does not allow for convenient access
and is not recommended.
Passenger Compartment Mounting
Mounting the EPX
adequate location. Leave sufficient room for the connection of cables
and be careful not to mount the unit near any vehicle computers or
sources of high voltage. Mount the RDAT in a location that provides
the user with easy access. Do not expose the RDAT to water, extreme
heat, or direct sunlight.
Engine Compartment Mounting
The Rockford Fosgate EPX
mounted in the engine compartment. Not only will this void your
warranty but could create an embarrassing situation caused by the
ridicule from your friends.
W
I R I NG T HE
1. Connect the EPX
The B+ lead should be connected to a source of non-switched 12
volts DC. Prepare the length of cable from the constant +12V by
stripping 3/8" of insulation from the end of the wire. Insert the
bared wire into the B+ terminal of the power connector and fasten
the screw. The total current consumption through this lead is
approximately 2 amps.
NOTE: The B+ cable MUST be fused 18" or less from the vehicle's
battery. Install a fuse holder, along with a 3 amp fuse, under the
hood and prepare the cable ends as stated above. Connections
should be water tight.
L
OCATIONS
should be mounted vertically whenever
2
main housing in the trunk is sufficient. Leave
2
main housing in the passenger compartment is an
2
main housing and RDAT should never be
2
S
YS T E M
power cable
2
-12 -
main housing and RDAT will
2
Hide quick links:
Advertisement
Table of Contents
