9. CLEANING
AND FLUSHING
Thoroughly
clean and flush the out-
board motor with fresh water after
operation in dirty or salty water.
Flushing
with
the Water
Hose
Joint
Do not run the engine dunng this
flushing
procedure.
For safety,remove
the emergency
stop switch clip, so the
engine cannot be started while you
are standing
near the propeller.
1. Remove the hose joint cap
---
H
WATER
JOINT
6
2. Install the water hose joint in the
water joint.
3. Connect
a water hose to the water
hose joint,
and turn on the water
supply.
102