Engine Oil - Honda HHT25S Owner's Manual

Blade Cover Removal
1. Turn the blade cover slowly until the cover latch is clear of the
debris shield.
Unfasten the latch by lifting the tab off the post.
2. Pull the post end away from the blade and set it on top of the blade
as shown.
3. Turn the blade cover slowly until the post end is clear of the debris
shield, then remove the blade cover from the blade.
Blade Cover Installation
1. Install the blade cover over the blade so half of the blade is
covered.
To prevent the post end from interfering with the debris shield, pull
the post end away from the blade and set it on top of the blade as
shown above.
2. Turn the blade cover slowly until the post end clears the debris
shield.
3. Reposition the post end over the blade.
4. With the blade cover fully seated on the blade, latch the tab over
the post.
6
POST
TAB
BLADE COVER
POST END
POST END

ENGINE OIL

The trimmer is shipped WITHOUT OIL in the engine.
Place the trimmer on a
level surface, and then
remove the oil filler
cap/dipstick.
A bottle of oil is included
in the box with your
trimmer. Add the entire
contents of the oil bottle
into the oil filler opening.
All Honda engines are
run at the factory prior to
packaging. Most of the
oil is removed prior to
OIL FILLER OPENING
shipment; however,
some oil remains in the
engine. The amount of
oil left in the engine
varies.
If not using the supplied oil, add enough recommended oil
to bring the oil level to the bottom edge of the oil filler hole.
Do not overfill the engine with oil, as the oil tank capacity is small.
NOTICE
Running the engine with too little or too much oil can cause engine
damage.
Screw in the oil filler cap/dipstick securely.
FUEL
See page 17.
BEFORE USING YOUR TRIMMER
On blade equipped models, always remove the blade cover before
starting the engine. If the cover is not removed, the blade cover may
fly off at high speed during test operation. Reinstall the blade cover
when the trimmer is not being used.
Before using the trimmer, all trimmer operators must read the
following sections.
• TRIMMER SAFETY (page
• CONTROLS & EQUIPMENT
• BEFORE OPERATION (page
• OPERATION (page 10)
• MAINTENANCE SCHEDULE
OIL FILLER
CAP/DIPSTICK
2)
(page 7)
9)
(page 14)
(page 15)