Controls And Equipment; Component Controls And Locations; Controls - Honda HHT25S Owner's Manual

CONTROLS AND EQUIPMENT

COMPONENT CONTROLS AND LOCATIONS

Loop Type Handle
CUTTING-LINE HEAD
GEAR CASE
LOOP HANDLE
DEBRIS SHIELD
WITH CUTOFF KNIFE
DRIVE CABLE
FRAME PIPE
IGNITION SWITCH
U-Type Handlebar
This type is supplied with a cutting-line head, a saw blade, and two
debris shields.
SAW BLADE
GEAR CASE
DRIVE CABLE
FRAME PIPE
DEBRIS SHIELD
FOR BRUSH/
WOOD BLADE
U-TYPE
HANDLEBAR
Engine
CHOKE LEVER
AIR
CLEANER
COVER
PRIMING
BULB
FUEL RETURN
TUBE (CLEAR)
FUEL SUPPLY
TUBE (BLACK)
HARNESS HANGER
THROTTLE SET BUTTON
OPERATOR
PRESENCE
LEVER
THROTTLE
TRIGGER
IGNITION SWITCH
THROTTLE
TRIGGER
THROTTLE
SET BUTTON
OPERATOR
PRESENCE
LEVER
HARNESS
HANGER
SPARK PLUG
SPARK
ARRESTER
STARTER
GRIP
OIL FILLER CAP
FUEL TANK CAP

CONTROLS

The location and operation of the controls are similar on both the
HHT25S and HHT35S models.
Choke Lever
The choke lever opens and closes the choke valve.
The CLOSED position enriches the fuel mixture for starting a cold
engine.
The OPEN position provides the correct fuel mixture for operation
after starting, and for restarting a warm engine.
CHOKE LEVER
CLOSED
OPEN
Ignition Switch
The ignition switch controls the ignition system.
The ignition switch must be in the ON (I) position for the engine to
start and run.
Moving the ignition switch to the STOP (O) position stops the engine.
U-type Handle:
STOP
(O)
ON (I)
IGNITION
SWITCH
OPERATOR
PRESENCE
LEVER
Operator Presence Lever
The operator presence lever blocks the throttle trigger. This safety
feature prevents unintentional throttle operation if the trimmer is
bumped while the operator's hand is not on the control handle.
When the operator presses the presence lever by gripping the control
handle, the trigger moves freely.
Loop Handle:
STOP (O)
ON (I)
OPERATOR
PRESENCE
LEVER
IGNITION
SWITCH
7