Honda FG110 Owner's Manual page 13

Fuel Tube Inspection
Check the fuel supply and return tubes, and replace any tube that is
damaged, cracked, or leaking.
FUEL
RETURN
TUBE
(clear)
FUEL
SUPPLY
TUBE
(black)
Refer to the Honda shop manual for tube replacement instructions, or
take the tiller to an authorized Honda servicing dealer.
Fuel Filter and Fuel Tank Cleaning
1. Remove the fuel tank cap.
2. Tip the tiller as shown and empty the fuel tank into an approved
gasoline container. Use a funnel to avoid spilling gasoline.
3. Pull the fuel filter out through
the fuel filler neck by hooking
the black fuel supply tube with
a piece of wire, such as a
partly straightened paper clip.
4. Inspect the fuel filter. If the fuel
filter is dirty, wash it with
nonflammable solvent. Be
careful to avoid damaging the
filter.
5. Replace the filter if it is
damaged or excessively dirty.
6. Rinse sediment from the fuel
tank with nonflammable
solvent.
7. Insert the fuel filter in the fuel
tank, and install the fuel tank
cap.
Fuel Storage Container
Store your gasoline in a clean, plastic, sealed container approved for
fuel storage. Close the vent (if equipped) when not in use, and store
the container away from direct sunlight. If it will take more than 3
months to use the fuel in the container, we suggest adding a fuel
stabilizer to the fuel when you fill the container.
If you have some fuel left in your storage container at the end of the
season, the Environmental Protection Agency (EPA) suggests adding
the gasoline to your vehicle's gas tank
(http://epa.gov/reg5oair/mobile/winter.html).
FUEL
WIRE
SUPPLY
TUBE (black)
FUEL
FILTER
13