Table of Contents
Advertisement
Window slider kit
minimum: 28 /8(72cm)
1
maximum:55 /8(140cm)
3
Fig. 8.2
3. Select the best location
Beside the window, door or French window.
Keep the distance between the return air outlet and the wall or
other obstacles to at least 20 inches (50cm)
Fix one end of the air hose on the air intake or outlet at the back of
the unit.
Extend the air hose to the clearance between window, door, or
French window, or wall hole.
Air outlet or intake should not be blocked by protective grid or
objects.
The distance between two ends of the air hose should be kept at
minimum of 8 inches (200mm)
Note: the cooling capacity will decrease if only the air discharge
hose is used, but air outlet temperature will be lower.
Installation instruction
Air outlet or intake opening should not be blocked by curtain, or
other objects.
Hose opening should not be block by shutters or other similar
objects.
Do not bend the air hose when assembling; keep it straight as
figure 3.
When operating in cool or dry mode, condensate will accumulate
in the water tank. When the tank is full, water full indicator will
light up (red) and LCD will display the sign E. The unit will stop
operating.
Shut off the power supply, pull out the rubber plug in drain port at
the rear of the unit, drained the water into a container or other
appropriate area.
Note: water should be drained off when the water full light is on,
otherwise, the appliance will not operate.
Technical Service Manual
10
1
3
Fig .8.3
Hide quick links:
Advertisement
Table of Contents
