Table; Figure - Grizzly G0580 Owner's Manual

Dust Collection
DO NOT operate this bandsaw without an ade-
quate dust collection system. This bandsaw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect a dust collection hose:
1.

Figure 25.

2.
Note: A tight fit is necessary for proper per-
formance.
Adjusting Positive
Stop
Tools Needed:
To set the positive stop:
1.
Tensioning Blade
Page 25
2.
3.
4.
Figure 26.
5.
6.
Note See Calibrating Table Tilt Scale on
Page 28.
Qty
Figure 26