13. Crank & Cam Angle / Water & Intake Temp, Knock Signal - GReddy e-manage ultimate Installation Manual

13. Crank & Cam Angle / Water & Intake Temp, Knock Signal
Crank Angle Signal & Cam Angle Signal
• Connect these wires for e-manage Ultimate to recognize the rpm signal from crank and cam
angle signal if there are no tach signal out put from the ecu. Also. by connecting these wires
Ignition timing can be monitored in the data log feature.
Female Connector
Male Connector
Splice
Grey/White (Crank Angle)
Connector C
Connector C
Grey/Black (Cam Angle)
If the Crank and Cam angle signal wires are connected to the ecu, e-manage will recognize
the rpm without connecting the rpm signal wire.
Knock 1 - 2, Water Temp Signal, Intake Temp Signal
•Connect these wire to the ECU Knock, water temp, or intake temp sensor signal to monitor them
in the data log feature.
•Also by connecting these wire to the water temp and/or intake temp signal the temperature
condition can be set in the software to activate relays with selected relay channels.
Female Connector
Male Connector
Splice
Blue/Yellow
(Knock 1 / Water temp)
Connector C
Connector C
Purple/Yellow
(Knock 2 / Intake temp)
ECU
(Engine Control Unit)
G
Ne
IMPORTANT
ECU
(Engine Control Unit)
Kn1/W
Kn2/A
20