Wiring Power, Ground, Airflow Meter, Throttle, Rpm Signal 12~13 - GReddy e-manage ultimate Installation Manual

8. Wiring Power, Ground, Airflow Meter,Throttle, RPM Signal
for RB26DETT (with 2 airflow meters)
Connector B
* The 2 wires for the airflow meter on the ECU will be connected together to the Airflow Output
wire.
* Make sure the jumper JP10 is set to "1-2" in the unit. This activates the Airflow Input 2 wire.
* Always use the provided connectors or solder all connections.
If the Ignition signal, Crank angle signal, or Cam angle signal wire is going to be wired, the
unit does not require the rpm signal wire to be connected to pick up rpm signal.
13
Gray (Throttle signal)
White (Airflow Input 1)
Yellow (Airflow Input 2)
Green (Airflow Output)
Brown (rpm signal)
Black (ECU Ground)
Red (12v IG power)
Female connector
Male connector
Splice
Important
× ×
ECU
(Engine Control Unit)