GReddy e-manage ultimate Installation Manual page 17

10. Injector Signal Wires
When changing I/J CH
Example: Changing group injection to sequential injection
Female connector
Male connector
Splice
Yellow/Red (I/J CH- 3 IN)
Orange/Red (I/J CH- 2 IN)
Blue/Red (I/J CH- 1 IN)
Connector B
Black/Red (I/J Ground)
Yellow/Red (I/J CH- 3 IN)
Orange/Red (I/J CH- 2 IN)
Blue/Red (I/J CH- 1 IN)
Connector C
Purple/Red (I/J CH- 4 IN)
Pink/Red (I/J CH- 5 IN)
Light Blue/Red (I/J CH- 6 IN)
Sub Injector Wiring
When using the CH for sub injectors
Connector B
Connect to
desired CH
When using low resistance injectors, dropping resistors are required to control the injectors.
ECU
(Engine Control Unit)
How to connect
• Connect the necessary I/J CH OUT wires to
the Connector C.
• The I/J CH Setting must be configured with
PC before starting the engine.
• Confirm the injector wiring to match the
injection method.
× × ×
# E
Injector
Dropping
Resistor
Important
When using high resistance injectors
When using low resistance injectors
16