Installation; Unpacking; Safety Information - Warnings; Placement - Furman ELITE-15 PF i Owner's Manual

Installation

Unpacking

Before unpacking your unit, inspect the carton for any obvious severe damage to the box and internal protective materials. If
internal damage is likely, contact the carrier who delivered the unit before proceeding with unpacking. If shipping damage is
evident on the product, then please contact your shipping carrier. Save all shipping and packing materials, as you may need
them if you should ever have to return the unit to the factory for servicing.
The box should contain the Elite-15 PF i unit, detachable AC cord, rack mount kit, owner's manual, and warranty registration
card. If anything is missing, please contact Furman Customer Service. Fill out and return your warranty registration card.
Registration is recommended because it can be used to establish whether the unit is within the warranty period should your
original ownership documents be lost, and it assists us in informing you about upgrades or other vital information.

Safety Information - Warnings

Please read and observe all of the safety and operating instructions before the Elite-15 PF i is operated. Retain these
instructions for future reference.
• Do not disassemble or modify in any way. No user-serviceable parts inside
• Keep away from moisture and avoid excessive humidity
• Do not allow liquids or foreign objects to enter the unit
The Elite-15 PF i should be serviced by qualified service personnel when:
• The power supply cord or plug has been frayed or cut.
• Objects have fallen or liquid has spilled into the unit.
• The Elite-15 PF i has been exposed to rain or other moisture.
• The Elite-15 PF i does not appear to operate normally, or exhibits a marked change in performance.
• The Elite-15 PF i has been dropped, or the enclosure damaged.
The Elite-15 PF i requires that a safety ground be present for proper operation.
Power Source
The power source to which the Elite-15 PF i is connected should be adequate for use at 15 Amps. The Elite-15 PF i will operate
with a10 Amp service outlet. However, nuisance tripping at the circuit breaker panel may result if the systems continuous
current draw exceeds 10 Amps.

Placement

The Elite-15 PF i is manufactured with four rubber feet for placement on any table, cabinet, shelf, or floor. These rubber feet
may be easily removed with a standard Philips screw driver when rack mounting adjacent to other components. Placement
or proximity to other components is not critical, and the Elite-15 PF i does not produce any appreciable heat under standard
use. The Elite-15 PF i may also be rack mounted in a standard 19" rack by attaching the Elite-15 PF i rack ears. These rack
ears (contained within the plastic rack kit package) mount flush with the back portion of the Elite-15 PF i's front panel. They
are attached to the chassis by installing each rack ear with (3) pan-head Philips screws contained within the Elite-15 PF i rack
mounting kit. The third screw used for each rack ear is for the center hole, located towards the rear and aids in stabilizing the
unit when rack mounted.