Using The Cli To Install Firmware - Qlogic iSR6142 Installation Manual

4 – Installation
Firmware Installation

Using the CLI to Install Firmware

To use the CLI to install the firmware, transfer the firmware image file from a
workstation to the router. Then use the CLI image unpack command to install
the new firmware image:
1. At the workstation prompt, use the ftp command to go to the location on the
router where you want to transfer the firmware image. For example:
C:\fwImage>ftp 172.17.137.190
Connected to 172.17.137.190.
220 (none) FTP server (GNU inetutils 1.4.2) ready.
2. Enter your username and password. For example:
User (172.17.137.190:(none)) – ftp
331 Guest login ok, type your name as password.
Password – ftp
230 Guest login ok, access restrictions apply.
3. At the ftp prompt, type BIN to set binary mode. For example:
ftp> bin
200 Type set to I.
4. Use the put command to transfer the firmware image file from the
workstation to the router. For example:
ftp> put isr-6142-2_2_0_x.bin
200 PORT command successful.
150 Opening BINARY mode data connection for
'isr-6142-2_2_0_x.bin'.
226 Transfer complete.
ftp – 4822816 bytes sent in 0.41Seconds
11878.86Kbytes/sec.
5. Type quit. The firmware image has been transferred to the router.
6. Log on to the router as an administrator.
(none) login – guest
Password – password
******************************************************
*
*
* *
******************************************************
QRouter#> admin start
Password
QRouter (admin) #>
4-12
QLogic Router Command Line Interface (QRCLI) *
– config
S
*
SN0051102-00 A