Using The Cli To Install Firmware - Qlogic iSR6200 Installation Manual

A message warns you that the router will be reset to activate the firmware.
4. Click OK to continue firmware installation, or click Cancel to cancel the
firmware installation.

Using the CLI to Install Firmware

To use the CLI to install the firmware, transfer the firmware image file from a
workstation to the router. Then use the CLI image unpack command to install
the new firmware image.
To install firmware in the CLI:
1. At the workstation prompt, use the ftp command to go to the location on
the router where you want to transfer the firmware image. For example:
C:\fwImage>ftp 172.17.137.190
Connected to 172.17.137.190.
220 (none) FTP server (GNU inetutils 1.4.2) ready.
2. Enter your user name and password. For example:
User (172.17.137.190:(none)): ftp
331 Guest login ok, type your name as password.
Password: ftp
230 Guest login ok, access restrictions apply.
3. At the ftp prompt, type bin to set binary mode. For example:
ftp> bin
200 Type set to I.
4. Use the put command to transfer the firmware image file from the
workstation to the router. For example:
ftp> put isr-6200-3_0_0_5.bin
200 PORT command successful.
150 Opening BINARY mode data connection for
'isr-6200-3_0_0_5.bin'.
226 Transfer complete.
ftp: 4822816 bytes sent in 0.41Seconds 11878.86Kbytes/sec.
5. Enter quit.
The firmware image has been transferred to the router.
6. Log on to the router as an administrator.
ISR651101-00 C
3–Installation
Installing New Firmware
3-13