Qlogic SANbox 5600 Series User Manual page 220

A – Command Line Interface
Image Command
11. Unpack the firmware image file to install the new firmware in flash memory.
12. Wait for the unpack to complete.
13. A message will prompt you to reset the switch to activate the firmware.
Resetting the switch is disruptive. Use the Hotreset command to attempt a
non-disruptive activation.
Examples
The following is an example of the Image Install command:
SANbox xxxx (admin) #> image install
Warning: Installing new firmware requires a switch reset.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
User Account
IP Address
Source Filename : 5.0.00.11_mpc
About to install image.
Connected to 10.20.33.130 (10.20.33.130).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
331 Password required for johndoe.
Password: xxxxxxxxx
230 User johndoe logged in.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
A-40
SANbox xxxx (admin) $>image unpack filename
image unpack command result: Passed
SANbox xxxx (admin) $>hotreset
: johndoe
: 10.20.33.130
Do you want to continue? [y/n] y
S
59097-02 B