Additional Settings; Advanced Network Settings; Online Users; Ip Filter - Q-See QC SERIES Setup Manual

ADDITIONAL SETTINGS

2.1 ADVANCED NETWORK SETTINGS

Now that you've successfully connnected your NVR to your network and to the Internet, there
are additional features which you can take advantage of. These settings allow your NVR to
send out e-mail alerts as well as post images and records to an FTP site. In addition, you can
see which users are online, limit online access and more.

ONLINE USERS

A list of users accessing the NVR from over
the network or through the Internet is shown
in Online Users menu which itself is found in
the Info menu.
The user's name as well as the IP address
used to access the NVR is displayed.
If you have proper system management rights
(Configured in Account, See Section 4.4
Advanced in the User's Manual for full
instructions), you can disconnect or block
a user. The maximum time a user can be
disconnected is 18 hours (65,535 seconds).
20
CHAPTER 2
PICTURE 2-1
PICTURE 2-2

IP FILTER

You can also improve security by controlling remote access to your NVR using the IP Filter.
This feature enables you to allow online users only from approved IP addresses. Up to 64
addresses may be entered.
The IP Filter window is accessed through
the Advanced Settings area of the
Network menu.
Enter the trusted IP addresses into the field at
the top of the window and select Add IP to
add that address to the list of those allowed
to connect to the NVR.
Once this feature is enabled, only IP
addresses within this list can be used to
access the NVR. If this feature is not enabled,
then users can connect from any IP address
if they have the correct user name and
password information.
NETWORK
0 . 0 . 0 . 0
IP Address DHCP
Subnet Mask 0 . 0 . 0 . 0
Gateway 0 . 0 . 0 . 0
TCP Port 37777 HTTP Port 80
UDP Port 37778 Max Connection 20
0 . 0 . 0 . 0
Preferred DNS
Alternate DNS 0 . 0 . 0 . 0
Latency
Transfer Mode
LAN Download
ADVANCED SETTING
IP Filter Trusted Sites : 0
NTP windows.time.com : 24
PPOE
DDNS No Available DDNS Setup
Default Save Cancel
PICTURE 2-3
PICTURE 2-4
21