Whirlpool SF315PEGN0 Use & Care Manual page 25

!iii i i_iiiii ii;,i_?ll_l _ii ii.......... Iiii!_ili!_i! _'ii!i_ iiiii 0iilii_ i_iI iii_ii:_iii iii:_ )
2, Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3, Rotate top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully seated
and engaged on the support pins.
4. Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5. Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6. Close the door.
Door stop [], _ Range
clip .................................................................. /_
I! . .................................
,111
Hinge
Door removal
I111
[ _"--"........................................ hanger
pinhole ...................................................................... _ (_ /
........................... Support pins
Front frame
hinge slot
Door removal
pin
II
Angular
of
door stop
clip
3. Remove the 2 hold-down screws at the rear of
the oven. If the screws are too tight to remove by
hand, use a screwdriver.
continued on next page
25