Foxconn IGPSK7MA series User Manual page 22

Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system's status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Button Connector (PWRBTN#)
Attach the connector to the power switch of the case. Pushing this switch allows
the system to be turned on and shut down.
Fan Connectors : CPU_FAN, FAN1
The fan speed of CPU_FAN, FAN1 can be detected and viewed in "PC Health
Status (O.T.S)" section of the CMOS Setup. These fans will be automatically
turned off after the system enters S3, S4 and S5 mode.
1
GND
+12V
CPU_FAN
CD_IN Connector: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN are Sony standard CD audio connectors, it can be connected to
a CD-ROM drive through a CD audio cable.
CD_R
GND
CD_L
S-ATA Connectors: SATA_1, SATA_2
The S-ATA header is used to connect the S-ATA device
to the motherboard. These connectors support the thin
Serial ATA cables for primary internal storage devices.
The current Serial ATA interface allows up to 150 MB/s
data transfer rate, faster than the standard parallel ATA
with 133 MB/s (Ultra ATA 133).
15
Chapter 2
SENSE SENSE
CD_IN
Installation Instructions
1
GND
+12V
FAN1
AUX_L
AUX_IN
GND
AUX_R
GND
RX+
RX-
GND
TX-
T X +
GND
SATA _1/SATA _2
2004-11-15, 17:36
15