Using The Met/Cal Calibration Software; Replaceable Parts - Fluke ProcessMeter 787 Calibration Manual

Model 787
Calibration Manual

Using the MET/CAL Calibration Software

To calibrate the UUT using the
follow the prompts.
For each function being calibrated, you will be prompted to set the UUT rotary
switch to the correct position, and to make the appropriate connections between
the calibrator, other required equipment, and the UUT.
Except for positioning the rotary switch and making the proper connections, the
calibration process is completely automated.
The MET/CAL Calibration Software program automatically puts the
Calibrator in Standby (STBY) mode before prompting you to change
connections.
To ensure your safety, however, always check the Calibrator to make
sure that it actually is in the Standby (STBY) before changing
connections with the UUT and all other equipment used in calibration.

Replaceable Parts

When servicing this ProcessMeter, use only the replacement parts specified. User-
replaceable parts are listed in Table 12 and shown in Figure 14.
Item
BT1
CG81Y
F1, 2
MP85
MP86
H2, 3, 4
MP89, 90
MP8
MP92
H5, 6
S1
TL75
AC70A
TL20
TM1
TM2
TM3
30
Table 12. Replacement Parts
Description
9V battery, ANSI/NEDA 1604A or IEC 6LR61
Holster, Yellow
Fuse, 440 mA, 1000 V fast-blow
Case top
Case bottom
Case screw
Non-skid foot
O-ring for input/output receptacle
Battery door
Battery door fasteners
Keypad
Standard test lead set
Alligator clips for use with TL75 test lead set
Industrial test lead set
Product Overview Manual
Users Manual (CD-ROM)
Calibration Manual (not shown)
MET/CAL Calibration Software, start MET/CAL and
Warning
Fluke No. Quantity
614487 1
CG81G 1
943121 2
619962 1
619939 1
832246 3
824466 2
831933 1
619947 1
948609 2
646932 1
TL75 1
AC70A 1
TL20 Option
1586717 1
1586721 1
641891 Option