Fluke 741B User Manual page 71

7. Press the softkey. The display changes to
Ramp
the following:
8. Fill in the parameters as prompted. Enter the
Start Value, End Value
9. To automatically stop ramping if a trip condition
is detected, set the
Trip Detect
select or
Voltage Continuity
gj41s.eps
, and
Ramp Time.
to , and
Enabled
as the trip function.
Documenting Process Calibrator
10. Press the softkey. Note the
Done
annunciator next to
SOURCE
display.
11. Select a low-to-high ramp or a high-to-low ramp
with the
Ramp Up/Down
12. To start ramping, press the
13. Ramping continues until a trip is detected (if
enabled), the ramp time expires, or you press
the softkey.
Stop Ramp
Using Source Mode
RAMP
at the top of the
softkey.
softkey.
Start Ramp
61