Fluke 741B User Manual page 37

4. Press or the
display appears as follows:
5. The string is shown at the bottom of the boxed
ID
area. To erase a character, press the
softkey. To erase the whole string, press
Space
.
6. Press , , , or
press . Use the numeric keypad if you
want to enter a number.
7. Repeat step 6 until you are satisfied with the ID
string appearing in the window.
softkey. The
Choices
gj40s.eps
Back
to select a character, then
Documenting Process Calibrator
8. Press the softkey.
Done
9. Press the softkey or
Done
mode.
Setting Up the Calibrator
to exit Setup
27