Festool Kapex KS120 Instruction Manual page 9

The MFT/Kapex has an MDF top, 525 mm x 815 mm with 20 mm holes spaced on 96 mm centers;
two extra rows of holes are to mount the Kapex. The total height of the MFT is 790 mm tall. The
height allows the Kapex's bed to be the same height of the MFT/3
(900 mm). It has the same V-groove profile as the MFT/3. The
profiles have slots for Festool clamps allowing work pieces to be
clamped to the side of the MFT. The guide rail hardware from the
MFT/3 can be attached to the MFT/Kapex. Soft, non-marking,
rubber feet on the MFT keep it from sliding around on the floor, the
front foot can be adjusted to level the MFT on an uneven floor.
MFT/Kapex is sold as an accessory (not included with the saw).
Brice Burrell, copyright 2008
Festool Kapex
It may seem out of order, but I want
to start with the MFT/Kapex since
you'll see it in almost ever picture.
It's used as the stand for the saw; it
can also be used as a work platform
for smaller projects or for a stand
for other tools. It's light weight so it
can be easily carried to or around
the job site. The MFT/Kapex can do
pretty much everything its big
brother, the MFT/3, can but only on
a smaller scale. Use it for clamping,
cutting, routing and so on.
MFT/Kapex
Page 9