Table of Contents
Advertisement
CLEANING & STORAGE
CARE AND MAINTENANCE
The body and lid of the housing are made of polycarbonate. Polycarbonate was selected for its outstanding
tensile strength, hardness, toughness and its crystal clear transparency/ high gloss surface. It has good
resistance to weathering, although long-term exposure to sunlight should be avoided. The normal operating
temperature range is from 3°C to 36°C [37-97°F]--Storage temperature: -10°C to 50°C) [14-122°F].
It is good practice to rinse off your housing with fresh water after every dive. Avoid exposure to fine sand.
After a series of 10 or more dives, e.g. after a dive holiday, it is recommended to immerse the housing for 2-3
hours in warm water to dissolve any salt deposits that may have built up. No chemical cleaners should be
used. Mild detergents e.g. shampoo and soap based cleaners are permitted.
Important!
FOR LONG-TERM STORAGE PLEASE REMOVE THE MAIN BODY TO LID GASKET.
TRAVELING
When transporting by air, please ensure the housing is not sealed to allow the air pressure to equalize;
removing the gasket is recommended.
Please protect the housing during transportation by wrapping it in foam or other protective wrapping.
ACCIDENTS
The impact resistance of the housing is excellent. However after an accident the alignment of the housing
may have been damaged. Therefore in the event of your housing suffering an impact force, e.g. being
dropped, it is essential you do not use the housing for diving. Please return the housing immediately for
Polycarbonate may be harmed by some household
chemicals--the housing should never be exposed to the
following classes of chemicals:
benzene, toluene, xylene, chlorinated hydrocarbons,
methanol, any other solvents, strong acids and bases
14
Advertisement
Table of Contents
