Mounting The Speedlight In The Housing - Fantasea F580EX Using Manual

Flash housing for canon 580ex speedlite

Hide thumbs Also See for F580EX:

Table of Contents

MOUNTING THE SPEEDLIGHT IN THE HOUSING

Since the Fantasea F580EX Flash Housing was specifically designed for the Canon 580EX Speedlight,

insertion is a simple matter of placing the flash into the housing. Make sure the flash is properly aligned and

that it sits perfectly flat. There are no screws or mounts to worry about or any other alignments once the flash

is properly inserted.

Set the flashlight in an upright position. Slide the flashlight all the way into the hot-shoe of the housing until

it stops.

Notes:

Turn the lock ring follow the direction "LOCK". Take care not to excessively tighten the screw. Note: If you

find that control levers do not locate properly with the buttons, please check again that the flashlight is

properly seated to the limit of the guide rail.

1. It is recommended first to attach the flash to the camera's

hot shoe to determine if it is functioning properly.

2. Once this is determined, insert both into their respective

housings.

LIDE THE

LASHLIGHT INTO THE

UIDE

Table of Contents