Base Grille - Whirlpool ET18MMXJT00 Use & Care Manual

7. Slipcompression sleeve a ndcompression nutoncopper
tubing asshown. Insert endoftubing intooutlet endsquarely
asfarasitwill g o.Screw compression nutonto outlet e nd
withadjustable wrench. Donotovertighten.
8. Place thefree endorthetubing intoacontainer orsink, a nd
turnONmain water s upply a ndflush outtubing until w ater i s
clear. Turn OFF shut-off valve onthewater p ipe. C oil c opper
tubing.
Connecting
to refrigerator:
1. Attach the copper tube to the valve inlet using a compression
nut and sleeve as shown. Tighten the compression nut. Do
not overtighten. Use the tube clamp on the back of the
refrigerator to secure the tubing to the refrigerator as shown.
This will help prevent damage to the tubing when the
refrigerator is pushed back against the wall. Move to step 2.
2. Turn shut-off valve ON. Check for leaks. Tighten any
connections (including connections at the valve) or nuts that
leak.
,_l 1
2
To remove the base grille:
1. Open the refrigerator door.
2. Grasp the grille with both hands.
3. Lift up and tilt the bottom of the grille toward you.
NOTE: Do not remove the Tech Sheet that is fastened behind the
grille.
To replace the base grille:
1. Open the refrigerator door.
2. Place upper clips in openings in the metal panel.
3. Roll the grille down toward the refrigerator until it snaps into
place.
1. Tube Clamp
2. Copper Tubing
3. Compression Nut
4. Valve Inlet
The ice maker is equipped with a built-in water strainer. If
local water conditions require periodic cleaning or a well is
your source of water supply, a second water strainer should
be installed in the ¼ in. (6.35 mm) water line. Obtain a water
strainer from your nearest appliance dealer. Install at either
tube connection.
4. Plug in refrigerator or reconnect power.