Table of Contents
Advertisement
Available languages
Available languages
NOTE: Having someone push against the top of the
Refrigerator takes some weight off the leveling legs.
This makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as
easily as you like. If not, tilt the Refrigerator slightly more
to the rear by turning both front leveling screws to the
left. It may take several more turns, and you should turn
both leveling legs the same amount.
Normal Sounds
Your new Refrigerator may make sounds that your old one
didn't make. Because the sounds are new to you, you
might be concerned about them. Most of the new sounds
are normal. Hard surfaces, such as the flooring and
surrounding structures, can make the sounds seem louder.
The following describes the kinds of sounds and what may
be making them.
•
Your Refrigerator is designed to run more efficiently to
keep your food items at the desired temperatures and to
minimize energy usage. The high efficiency compressor
and fans may cause your Refrigerator to run longer than
your old one. You may also hear a pulsating or high-
pitched sound from the compressor or fans adjusting to
optimize performance.
•
Rattling noises may come from the flow of refrigerant or
items stored inside the Refrigerator.
•
As each cycle ends, you may hear a gurgling sound due
to the refrigerant flowing in your Refrigerator.
•
You may hear water running into the drain pan when the
Refrigerator is defrosting.
•
You may hear clicking sounds when the Refrigerator
starts or stops running.
Tools Needed: Phillips screwdriver
Remove the Base Grille
1. Open the Refrigerator door.
2. Using the screwdriver, remove the two screws.
3. Remove the base grille.
Replace the Base Grille
1. Open the Refrigerator door.
2. Position the base grille so that screw
REFRIGERATOR USE
The control panel is located on the left side of the
compartment and facing front center. The control panel
has no mechanical parts or buttons.
Turning Control On/Off
The first time that the Refrigerator is plugged in, the control
will be in Off mode.
To turn ON the unit, press
To turn OFF the unit, press
Viewing Celsius Temperatures
Press the
the temperature in degrees Fahrenheit
and degrees Celsius. The corresponding
indicator will illuminate.
Adjusting the Controls
There are three temperature control set points for this
model: For your convenience, your control is preset at the
default temperature.
7
Base Grille
holes align into place. Replace the two screws.
Tighten the screws.
Using the Control
touch pad to toggle between displaying
button for 3 seconds.
button for 3 seconds.
Advertisement
Table of Contents
