Door Closing; Base Grille - Whirlpool WUR50X24HZ Use & Care Manual

Door Closing

Your Refrigerator has two leveling legs. If your Refrigerator
seems unsteady or you want the door to close more easily,
adjust the Refrigerator's tilt using the instructions below.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
2. Move the Refrigerator into its final location.
3. Turn the leveling legs to the right to lower the Refrigerator or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the Refrigerator.
NOTE: Having someone push against the top of the
Refrigerator takes some weight off the leveling legs. This
makes it easier to adjust the leveling legs.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the Refrigerator slightly more to the rear
by turning both front leveling screws to the left. It may take
several more turns, and you should turn both leveling legs
the same amount.
6

Base Grille

Tools Needed: Phillips screwdriver
Remove the Base Grille
1. Open the Refrigerator door.
2. Using the screwdriver, remove the two screws.
3. Remove the base grille.
Replace the Base Grille
1. Open the Refrigerator door.
2. Position the base grille so that screw holes align into place.
Replace the two screws. Tighten the screws.