Installing Ridgeline On A Multi-Homed Server - Extreme Networks Ridgeline Installation Manual

Chapter 3: Installing the Ridgeline 3.1 Server
jboss ports 3873, 8080 (default), and 8083, which allow the Ridgeline server to talk to the client
●
HTTP port 8334, which allows switches to talk to the Ridgeline server in HTTPs mode
●
FreeRADIUS port 10559 (default)
●
TCP port 56983 for the client to connect to the server in NAT-enabled environments
●
7 Restart the Ridgeline server, as described in the previous section.

Installing Ridgeline on a Multi-Homed Server

A multi-homed server has more than one network interface card (NIC) installed and might be using
multiple IP addresses. If you are installing Ridgeline on a multi-homed server, you must specify either
the IP address or hostname that Ridgeline clients should use when communicating to the Ridgeline
server. You also specify which IP address Ridgeline should use when communicating with managed
devices, or simply let Ridgeline choose the IP address automatically.
Ridgeline 3.1 provides a Ridgeline Server Setup Utility that simplifies the process of configuring
Ridgeline interfaces. The configuration options are:
Select a single IP address for communication with Ridgeline clients and network devices. Other host
●
IP addresses are unused by Ridgeline. Although this is a valid Ridgeline setting, and is presented in
the setup utility, it is not useful for multi-homed systems because it only utilizes a single interface.
Set a hostname that Ridgeline clients can use to communicate with the Ridgeline server, and let
●
Ridgeline choose the IP address to communicate with network devices.
Set a hostname that Ridgeline clients can use to communicate with Ridgeline, and specify an IP
●
address that Ridgeline uses to communicate with network devices.
To configure Ridgeline for multi-homed servers:
1 Stop the Ridgeline server. See
2 Start the Ridgeline Server Setup Utility:
On a Windows system, from the Start menu go to:
●
Programs > Extreme Networks > Ridgeline3.1 > Server Setup Utility
On Linux, the server setup utility from symbolic link is in /root/ExtremeNetworks/
●
Ridgeline3.1/Server Setup Utility.
The Ridgeline Server Setup Utility dialog box opens.
44
"Starting and Stopping the Ridgeline Server" on page 41.
Ridgeline Installation and Upgrade Guide