Advertisement
Available languages
Available languages
Section 3: Assembly
4.
5.
Place a washer on axle and then place an e-ring in axle
groove.
Install e-ring with pliers, squeezing from top of e-ring
to bottom
of axle.
CAUTION
• Always wear eye protection when installing/removing e-rings.
6.
Repeat step 3 thru 5 to secure second wheel.
7.
Tip generator
so that engine side is down.
8.
Attach support leg using 2 capscrews (M8 x 20 mm)
and 2 hex nuts.Tighten
with a 13mm socket wrench
and 13mm wrench.
9.
Return generator
to normal operating position
(resting
on wheels and support leg).
10. Loop handle pins to generator
frame as shown in
Figure I. Raise handles and insert handle pins to move
generator.
I I. Check each fastener to ensure it is secure and the
dres are inflated between
15-40 PSI.
ELECTRIC
START
Your unit is equipped
with electric
start capability
but can
be started
manually. If you choose
not to use the electric
start feature,
you do not need to connect
the negative
battery
cable.
Check
Battery
/ Attach
Negative
Battery
Wire
The sealed battery on the generator
is fully charged and
pre-installed
except
for the negative
(black) battery
cable.
To install:
I.
Cut off tie wrap securing
loose end of negative
(black)
cable.
2.
Using an 8 mm socket
wrench,
remove
screw, loci<
washer
and flat washer
on negative
battery
terminal.
3.
Slide lock washer, fiat washer
and negative battery
cable over screw (Figure 2).
Positive
Screw
Flat Washer
Negative
Battery
Cable
4.
Reattach
screw
to negative
battery
terminal
and
tighten.
5.
Verify
that
connections
to battery
and generator
are
tight
and secure.
O
Advertisement
