Troy-Bilt 030247-1 Operator's Manual page 16

Maintenance
GENERAL
RECOMMENDATIONS
Regular maintenance wiii improve the performance and
extend the life of the generator. See any authorized dealer
for service.
The generator's warranty does not cover items that have
been subjected to operator abuse or negligence.To receive
fuji value from the warranty, the operator must maintain
generator as instructed in this manual
Some adjustments wiii need to be made periodically to
properly maintain your generator.
All service and adjustments should be made at [east once
each season. Follow the requirements in the "Maintenance
Schedule" chart below in Figure i 5.
NOTE: Once a year you should clean or replace the spark
plug and replace the air fiiter.A new spark plug and clean
air filter assure proper fuel-air mixture and help your
engine run better and last longer.
GEN ERATO R
MAINTENANCE
Generator maintenance consists of keeping the unit clean
and dry. Operate and store the unit in a clean dry
FILL IN DATESASYOU
COMPLETE REGULAR SERVICE
MAINTENANCE TASK
Check oil level
Clean debris
Service air cleaner pre-filter
Change engine oil
Service air cleaner paper filter
Service spark plug
Service spark arrester
Clean cooling system
Check valve clearance
Before
Each Use
X
X
environment where it will not be exposed to excessive
dust, dirt, moisture or any corrosive vapors. Cooling air
slots in the generator must not become clogged with snow,
leaves, or any other foreign material.
Check the cleanliness of the generator frequently and clean
when dust, dirt, oil, moisture or other foreign substances
are visible on its exterior surface.
NOTE: DO NOT use water or other liquids to clean
generator. Liquids can enter the engine fuel system causing
poor performance and / or failure to occur. In addition, if
liquids enters the generator through cooling air slots, some
of the liquid will be retained in voids and cracks of the rotor
and stator winding insulation. Liquid and dirt buildup on the
generator internal windings will eventually decrease the
insulation resistance of these windings.
Generator Cleaning
Daily or before use, clean accumulated debris from
generator. Keep linkage, spring and controls clean. Keep area
around and behind muffler free from any combustible debris.
Inspect cooling air slots and openings on the generator.
These openings must be kept clean and unobstructed.
Generator parts should be kept clean to reduce the risk of
overheating and ignition of accumulated debris.
Use a damp cloth to wipe exterior surfaces clean.
Use a soft bristle brush to loosen caked on dirt, oil, etc.
SERVICE DATES
Every 25 Hours Every 50 Hours
or Yearly or Yearly
X 2
X I
Every I00 Hours
or Year y
SERVICE DATES
X 2
x
x
x 2
x
Prepare for storage If unit is to remain idle for longer than 30 days.
Change oil after the first (5) operating hours and every 50 hours or every year, whichever occurs first, thereaffett
Change sooner when operating under dirty or dusty conditions.
2 Clean or replace more often under dirty or dusty conditions.
O