Programming The Remote Control For Use With A Non-Toshiba Vcr Or Cable Tv Converter - Toshiba 34HD82 Owner's Manual

(Continued from previous page)
To control a cable TV converter:
1. Program the remote control to recognize your converter brand.
2. Set the TV/CABLE/VCR switch to the CABLE position.
The shaded buttons shown at right will then control the
cable TV converter.
Programming the remote control for use with a
non-Toshiba VCR or cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs. To
use VCRs or cable converters other than Toshiba models, you must
follow the steps below before you operate your remote control.
1. Refer to the VCR and cable TV converter code tables on pages 17
and 18 to find the code for your VCR or converter brand.
If more than one code is listed, try each one separately until you
find one that works.
2. If you are reprogramming the remote control to operate your:
• VCR—set the TV/CABLE/VCR switch on the remote
control to VCR.
• Cable TV converter—set the TV/CABLE/VCR switch on
the remote control to CABLE.
3. While holding down the RECALL button, press the Channel
Number buttons (0–9) to enter the three-digit code for your
VCR or converter brand.
4. Point the remote control at the VCR or converter and press
POWER to test the code.
If the VCR or converter turns on, you have entered the correct
code.
If the VCR or converter does not respond to the remote control,
you may have entered the wrong code. Repeat steps 1–4 using
another code.
5. Reset the TV/CABLE/VCR switch to "TV" to control the TV.
For future reference, write down the codes you used:
VCR code:
Cable TV converter code: _____________________
16
_____________________
RECALL
LIGHT RECALL POWER
POWER
TV
CABLE
MUTE TV/VIDEO TIMER
VCR
1 2 3
Channel yz
CH
4 5 6
Channel
7 8 9
Number
VOL
CH RTN
0
100
ENT
Enter
ADV/
POP CH
MENU/
FAV FAV
ENTER
ADV/
POP CH
STOP SOURCE PLAY PIP
Note:
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2. "
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.