Toshiba Regza 52RV535U Owner's Manual page 5

52RV535U ENbook Page 5 Tuesday. July 22, 2008 5:25 PM
Choosinga location for your LCDTV
To Display yourLCDTV onthe included Pedestal
Stand:
Observe the following safety precautions:
1) Read and Follow thepedestal assembly instructions
included with the pedestal.
CAUTION: Before beginning pedestal assembly,
carefully lay the front of the LCD Panel face down on a
flat, cushioned surface such as a quilt or blanket. Leave
the bottom of the unit protruding over the edge of the
surface and assemble the pedestal as indicated below.
Note: [:iixtremecare should always be used when attaching
the pedestal stand to avoid damage to the LCD panel
2) Place the TV on a sturdy, level surface that can support
the weight of the TV.
3) Be sure to secure the TV to a wall stud, pillar, surface, or
other immovable structure. To secure the TV in this
manner: (1) attach the provided securement clip to an
immovable structure, then (2) pass a sturdy strap
through the securement clip and attach each end to the
hooks located on the back of the TV. Be sure to leave at
least 4 inches between the TV and the wall or similar
structure for ventilation. See item 20, page 3 for
additional details.
To Display yourLCDTV usinga Wall Bracket:
If you decide to wall mount your LCD TV, always use a UL-
listed wall bracket appropriate for the size and weight of the
LCD TV (r,v page 2) :
1) CAUTION: Two people are required
for installation.
2) Unplug and remove any cables and/or other component
connectors from the rear of the TV.
3) Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate bracket(s)
are attdched to theewall and the back- of the TV as
described in the instructions provided with the wall
bracket.
4) After attaching_ the a_9 9ro_griate bracket(s)_ to the wall and
the back of the TV, remove the pedestal stand from the
TV as described below.
Removing the PedestalStand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the
stand protruding over the edge of the surface.
Note: [:iixtremecare should always be used when removing
the pedestal stand to avoid damage to the LCD panel
2) Remove the four screws shown in the diagram below.
This will allow removal of the pedestal stand.
3) Once you have removed all four screws holding the
pedestal stand in place, remove the pedestal strand from
the TV by sliding the pedestal stand away from the TV.
Four screws
RV535U (E/F) Web 213:276